Newbie install problem
first thing, get rid of anything gimp that occures underneath /usr.
best way is to use the unistall rpm options, but even then, check for
libgimp and for /usr/bin/gimptool. make might be finding these things.
once that is done, run ldconfig.
then rm config.cache.
then ./configure. watch the config spew. config complains if there is
a problem or something unusual.
good luck. it is worth it. red hat has some screwed up gimp rpms.
carol
On 2002-05-10 at 2124.00 -0600, Ralph Jones typed this mail:
I just upgraded my Redhat installation from 7.1 to 7.2, and the first time
I started Gimp 1.2.1 it put out a long series of "Can't load" and
"compilation aborted" messages. The GUI comes up OK, but it looks as if a
lot of the plugins didn't load.
I then installed Gimp 1.2.3 via the config/make/make install route from
/usr/local/src/gimp-1.2.3, and it produces the same result.
Suggestions? Thanks...
rj
